do88 intercooler
Will fit:
Saab 9-5 - 1998-2010 - all 2.0 and 2.3 petrol and BioPower version (B205, B235)
Developed by do88 to replace the original / OEM intercooler and gives true performance without the need of rebuilding the whole car!
Significant advantages with do88 performance intercooler (OEM intercooler):
- Core volume: 11803 m3 (6379 cm3), do88 is 85% larger
- Air flow at 0,15 bar / 2,18 psi pressure drop: 296 CFM (227 CFM), do88 30% higher, see diagram in the photo gallery
- Post intercooler air temperature at same conditions: 32 °C (53 °C) do88 21°C lower, see diagram in the photo gallery
do88 performance intercooler are an all-aluminum construction with cad designed, flow optimized cast end tanks and optimized core design to achieve best possible cooling efficiency combined with lowest possible pressure drop.
Always remember that the OEM intercooler was designed for the power level the car was built for and a power increase or even very hard use of the car in a standard version may cause that the OEM intercooler don’t have the performance you need. So only after engine software tune do88 performance intercooler will give a performance increase over the OEM intercooler.
The OEM intercooler have plastic tanks that don’t keep up with higher boost levels very well so the do88 performance intercooler will also add reliability!
A common misunderstanding is that an intercooler installed in this position cannot provide good performance and a front mounted intercooler would be much better. Actually the do88 performance intercooler are far better than most front mounted interdooler installations where only a core with small front surface are possible to install and often also installed partially behind the bumper beam which will reduce cooling capacity even further and often cooling below the OEM intercooler are achieved.
do88 performance intercooler comes with all brackets and screw holes which necessary for an safe and easy installation.
Note!
Some modifications may be required at versions of MY 1998-2001.
The headlight housing may have to be trimmed to not interfere with the AC-condenser.
The sensor attached behind the intercooler pipe may have to be slightly relocated.
Will fit:
Saab 9-5 - 1998-2010 - all 2.0 and 2.3 petrol and BioPower version (B205, B235)
Developed by do88 to replace the original / OEM intercooler and gives true performance without the need of rebuilding the whole car!
Significant advantages with do88 performance intercooler (OEM intercooler):
- Core volume: 11803 m3 (6379 cm3), do88 is 85% larger
- Air flow at 0,15 bar / 2,18 psi pressure drop: 296 CFM (227 CFM), do88 30% higher, see diagram in the photo gallery
- Post intercooler air temperature at same conditions: 32 °C (53 °C) do88 21°C lower, see diagram in the photo gallery
do88 performance intercooler are an all-aluminum construction with cad designed, flow optimized cast end tanks and optimized core design to achieve best possible cooling efficiency combined with lowest possible pressure drop.
Always remember that the OEM intercooler was designed for the power level the car was built for and a power increase or even very hard use of the car in a standard version may cause that the OEM intercooler don’t have the performance you need. So only after engine software tune do88 performance intercooler will give a performance increase over the OEM intercooler.
The OEM intercooler have plastic tanks that don’t keep up with higher boost levels very well so the do88 performance intercooler will also add reliability!
A common misunderstanding is that an intercooler installed in this position cannot provide good performance and a front mounted intercooler would be much better. Actually the do88 performance intercooler are far better than most front mounted interdooler installations where only a core with small front surface are possible to install and often also installed partially behind the bumper beam which will reduce cooling capacity even further and often cooling below the OEM intercooler are achieved.
do88 performance intercooler comes with all brackets and screw holes which necessary for an safe and easy installation.
Note!
Some modifications may be required at versions of MY 1998-2001.
The headlight housing may have to be trimmed to not interfere with the AC-condenser.
The sensor attached behind the intercooler pipe may have to be slightly relocated.
Average ratings